I need a couple racks fabricated to hold the pin\/splines from my tube molds. The plan is to shoot the molds in one color, remove the baits from the molds (leaving them on the pin\/spline) and then dipping the body into a second color. They need to cool for a minute or so before they can be removed from the pin\/spline and shouldn't be touching anything else including each other during the cooling process.\n\nI can provide the necessary dimensions but I am reluctant to mail you samples because it is highly probable that these molds won't be made again. I got my 3.5" molds during the second to last run and the 2" molds I barely got in on the last run. I'll post a picture of the pin\/splines from my phone.